PCI bus Test Socket, PCI Express Test Socket
* PCI card plugged into connector figure
Attention:
1. Whole signals bus Test Socket/Converter/Extender maybe not 100% one to one(1:1)
convert, please check specification.
2. No matter how many Slot/Socket, PCI/PCIe series only can use one Slot/Socket at a time.
3. All Converters/Test Socket/Riser card/Extender have Timing, Delay, Impedance,
Resistance Contact problem, so we can't guarantee can work100%.
4. External converter card, if occur unreliable, try to shorten the cable to better this status.
simple PCI hot swapping and hot plugging card
CV09P-NF PCI bus Test Socket
1. Switch PCI bus power source(+12v, -12v, +5v,+3.3v) ON-OFF,
PCI add-in card can insert in Power- ON, but must carefully to avoid signal or power shortage
and equipment damage.
2. Push Micro SW to Reset signal generator.
3. Run real hot plugging function in operation system,
must write PCI device configuration register Read-Writer program.
4. Schematics: 09p1.pdf, 09p2.pdf
CV09P-S PCI bus Test Socket
1. All of PCI bus signals(120p), can use Jumper setup ON-OFF, easy for add-on card
debug.
2. Besides stand slot, with Left-angle/side slot hole pads x1 and Right-angle/side slot hole pads x1,
can select add-on card component on top or down for test or measurement.
* Schematics: 09p1.pdf, 09p2.pdf
CV09P-S-NF PCI bus Test Socket
1. The CV09P-S-NF combine CV09P-NF with CV09P-S.
2. This function please view CV09P-NF and CV09P-S.
* Schematics: 09p1.pdf, 09p2.pdf
| PCI Express Test Socket | |
| * Easy for Logic Analyzer and
Oscilloscope to measure PCIe bus every pin signal. * Gold fingers pin to pin(1 to 1) connect to slot, the common pin Power and Ground didn't connect with together. |
|
| 1. CV09PE-1S(PCIe x1) | inquiry |
| 2. CV09PE-4S(PCIe x4) | inquiry |
| 3. CV09PE-8S(PCIe x8) | inquiry |
| 4. CV09PE-16S(PCIe x16) | inquiry |
| Home | Index |   |
Start: 8/30/2001 Update:04.01.2011